SPRAY GUN
The dual cartridge spray gun is pneumatically driven and is designed to dispense the 1:1 100% solids RhinoPro™ coatings held in disposable cartridges. This is a quality product for the professional user; it is designed for high duty cycles over long operating periods.
The RhinoPro™ Cartridge System will increase your productivity while significantly reducing the labor costs associated with set-up and clean-up since most parts are disposable. The RhinoPro™ system is completely air driven, no electricity needed. The dual cartridge spray gun utilizes a standard quick disconnect for easy attachment to your air supply.
RhinoPro Cartridge Guns can be used for a variety of coating projects, including:
- Truck Bedliners
- Insurance repairs and patching of damaged liners
- Cooling tower pans
- Hard to reach places
- Motor home and trailer roof and floor coatings
- Van and SUV conversion interior linings
- Industrial equipment liners and coatings
- Stairs
Operation
CONNECTION
The compressor supplying air to the gun needs to be
capable of supplying 10 CFM @ 100 PSI. For optimum
performance the supply pressure must be greater than 100
P.S.I (6.8 bar) and less than 145 P.S.I. (10 bar).
PRESSURE REGULATOR
The pressure regulator controls the flow rate. To
increase the flow, turn the knob in a clockwise (+)
direction. To decrease the flow, turn the knob in a
counter clockwise (-) direction.
TRIGGER
By pulling the trigger, a cushion of compressed air is
built up inside the applicator, which initiates the
flow. On releasing the trigger, the flow ceases
instantly as the compressed air escapes via the quick
exhaust valve at the rear of the gun.
PLUNGER RETURN BUTTON
Press and hold the plunger return button, then pull the
trigger. This will pull back the plunger rods
automatically ready for the next cartridge.